Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

incoming call problem

I have a cm 6.1.2, the problem is that when i receive an international missed call i can not reial the number because the 00 is missing from the number (example: 944161....)

The call manager is connected to pstn gateway but there are no translation rules that affect the international numbering.

Can you please advice.

Thank you.

2 REPLIES

Re: incoming call problem

ok the following link very nice and will guid u set by step to do this although it is for version 4 but the idea exactly yhte same and in this link they add 9 for missed calls u can make 00 and the matching number u can make it more spicific for international calls to get it work corectly have a look :

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805b6f33.shtml

good luck

if helpful Rate

New Member

Re: incoming call problem

I have tried what you told me. But it did not work.

In front of the call manager we have a voice gateway (2811 router) connected to a pri line from the telco.

I think the best is to change the translation rules we have our translation rules are:

translation-rule 1

Rule 0 ^0.% 90

Rule 1 ^1.% 91

Rule 2 ^2.% 92

Rule 3 ^3.% 93

Rule 4 ^4.% 94

Rule 5 ^5.% 95

Rule 6 ^6.% 96

Rule 7 ^7.% 97

Rule 8 ^8.% 98

Rule 9 ^9.% 99

Rule 10 ^00.% 900

The last statement i added for testing.

I our country the dialling plan for land line is 2xxxxxxx (8numbers), for mobiles is 9xxxxxxx.

I believe this translation rule is only for local dialling ?

Can i create a another dial rule for international numbers and applied to the same dial peer ?

I will show you the dial peers:

translation-rule 1

Rule 0 ^0.% 90

Rule 1 ^1.% 91

Rule 2 ^2.% 92

Rule 3 ^3.% 93

Rule 4 ^4.% 94

Rule 5 ^5.% 95

Rule 6 ^6.% 96

Rule 7 ^7.% 97

Rule 8 ^8.% 98

Rule 9 ^9.% 99

Rule 10 ^00.% 900

!

!

translation-rule 2

Rule 1 1000 1297

Rule 8 1222 1296

Rule 9 1200 1296

Rule 10 1010 1298

!

!

translation-rule 3

Rule 1 1000 1005

Rule 2 1200 1201

Rule 3 1222 1201

!

!

!

!

interface FastEthernet0/0

description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-I

ip address 192.168.x.x 255.255.255.0

duplex auto

speed auto

h323-gateway voip interface

h323-gateway voip h323-id PSTN_GATEWAY

h323-gateway voip bind srcaddr 192.168.x.x

!

interface FastEthernet0/1

no ip address

shutdown

duplex auto

speed auto

!

interface Serial0/0/0:15

no ip address

encapsulation hdlc

ip mroute-cache

no logging event link-status

isdn switch-type primary-net5

isdn timer T310 60000

isdn incoming-voice voice

isdn sending-complete

no cdp enable

!

ip route 0.0.0.0 0.0.0.0 192.168.x.x

!

!

!

control-plane

!

!

!

voice-port 0/0/0:15

translate called 2

echo-cancel coverage 32

cptone CY

bearer-cap Speech

!

!

!

!

dial-peer cor custom

!

!

!

dial-peer voice 3 pots

destination-pattern 9T

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 5 pots

destination-pattern 516T

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 6 pots

destination-pattern 517T

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 7 pots

destination-pattern 518T

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 4 pots

destination-pattern 515T

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 1 voip

shutdown

destination-pattern 1...

translate-outgoing calling 1

voice-class codec 2

voice-class h323 1

session target ipv4:192.168.x.x

dtmf-relay h245-alphanumeric

no vad

!

dial-peer voice 2 voip

preference 1

shutdown

destination-pattern 1...

translate-outgoing calling 1

voice-class codec 2

voice-class h323 1

session target ipv4:192.168.x.x

dtmf-relay h245-alphanumeric

no vad

!

dial-peer voice 10 pots

destination-pattern 7T

progress_ind alert enable 8

direct-inward-dial

port 0/0/0:15

!

dial-peer voice 60 voip

destination-pattern 1[6-9]..

voice-class codec 10

session target ipv4:10.1.x.x

dtmf-relay h245-alphanumeric

!

dial-peer voice 100 voip

preference 2

destination-pattern 1199

voice-class codec 3

session target ipv4:10.0.x.x

dtmf-relay h245-alphanumeric

fax-relay ecm disable

fax protocol t38 ls-redundancy 0 hs-redunda

no vad

!

dial-peer voice 150 voip

destination-pattern 1299

translate-outgoing calling 1

voice-class codec 2

voice-class h323 1

session target ipv4:192.168.x.x

dtmf-relay h245-alphanumeric

no vad

!

dial-peer voice 1000 voip

preference 1

destination-pattern 1...

translate-outgoing calling 1

voice-class codec 2

voice-class h323 1

session target ipv4:192.168.x.x

dtmf-relay h245-alphanumeric

no vad

Can you please advice..

114
Views
0
Helpful
2
Replies
CreatePlease to create content