Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Incoming Call Routing

Hi all,

I'm facing an issue at a customer site and dunno how to solve it.

Maybe someone could help.

My customer is running UC520 with 1 E1 card and 1 BRI with. Each card for 2 differents customers.

So my E1 for Cust1 and the BRI for Cust2.

My issue is related to incoming call. Both customer would like to translate extension '1' to an ephone-dn.

But how can I do to say "Ok, when someone will call the PRI with extension 1, it will be directed to XXX, but when someone will call the BRI with extension 1, it will be directed to YYY.

Here is my config, but it doesn't work at all.

voice translation-rule 10

rule 1 /^1$/ /311/

voice translation-rule 15

rule 1 /^1$/ /211/

voice translation-profile Cust1

translate called 10

voice translation-profile Cust2

translate called 15

voice-port 0/2/0:15

cptone LU

compand-type a-law

timeouts interdigit 2

bearer-cap Speech

!

voice-port 0/1/0

cptone LU

compand-type a-law

timeouts interdigit 2

bearer-cap Speech

dial-peer voice 200 pots

corlist outgoing callBT

description ** E1 Outgoing/Incoming CUST1 **

translation-profile incoming Cust1

destination-pattern 0T

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

incoming called-number .T

direct-inward-dial

port 0/2/0:15

!

!

dial-peer voice 100 pots

corlist outgoing callRadianz

description ** BRI Outgoing/Incoming CUST2 **

translation-profile incoming Cust2

destination-pattern 0.T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

incoming called-number .T

direct-inward-dial

port 0/1/0

Some help would be greatly appreciated :)

Fabian

4 REPLIES
Silver

Re: Incoming Call Routing

How many digits does your Telco send? From the translation pattern it looks for only a complete match on teh digit 1. It may be better to change it to rule to /^1../ /211/ if they send you 3 digits

New Member

Re: Incoming Call Routing

hi,

My telco send the necessary digit. It's not the issue. The pb is that sometime it translate 1 to 211, and sometime to 311...

Fabian

Re: Incoming Call Routing

Fabian,

Try the following.

1. Remove the translation profile from dial peers 100 and 200.

2. Modify the "incoming called-number" command on these dial peers to be "incoming called-number ."

3. Apply the translation profiles to the voice ports:

voice-port 0/2/0:15

translation-profile incoming Cust1

voice-port 0/1/0

translation-profile incoming Cust2

Hope this helps.

Brandon

New Member

Re: Incoming Call Routing

Hi Brandon,

Thx for your answer. I'll try it tomorrow.

I keep u informed.

Fabian

112
Views
0
Helpful
4
Replies