Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Incoming CALL

hi,

i have configured a H323 getaway with a Cisco unified 7.0.

for the all incoming call i configured that to be destined to the extension number 1000 .

but if i change the partition + CSS form NONE , no incoming call is ringing.

also want to enable the caller id for the incoming call??

the IOS version is (C2800NM-IPVOICEK9-M), Version 12.4(22)YB.

Many thanks in advance

1 REPLY
Cisco Employee

Re: Incoming CALL

dial-peer voice 1001 voip

destination-pattern 1000

progress_ind setup enable 3

session target ipv4:192.168.31.2

dtmf-relay h245-alphanumeric

codec g711ulaw

that's the dial-peer you're using, that simply tells which CUCM to send the H225 signaling. in CUCM you still need to have a valid incoming CSS configured under the H323 GW to reach DN 1000 on whatever partition it is

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
114
Views
0
Helpful
1
Replies
CreatePlease to create content