Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Incoming called number

Hi,

I need to know if my understanding is correct, can the command incoming called-number command be used in the fxo interface in the gateway or it is limited to an T1 E1 interface.

Thanks

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Incoming called number

incoming called number used to match the called number in the inbound dialpeer

with FXO you have one number associated with it which mean always one number to be called ( no need )

however with E1/T1 there is a range of numbers in this case you may need to make some changes or translations only to some called numbers( part of the range)  in this case this command will be useful

hops this helps

if helpful Rate

2 REPLIES

Re: Incoming called number

incoming called number used to match the called number in the inbound dialpeer

with FXO you have one number associated with it which mean always one number to be called ( no need )

however with E1/T1 there is a range of numbers in this case you may need to make some changes or translations only to some called numbers( part of the range)  in this case this command will be useful

hops this helps

if helpful Rate

Hall of Fame Super Silver

Re: Incoming called number

Can you provide us a reason you would want to do this?  As stated FXO line is always tied to one incoming called number, perhaps you meant FXS/DID line which can have mutliple DIDs arive on the same port in which case you can use the command.

HTH,

Chris

4519
Views
0
Helpful
2
Replies
CreatePlease to create content