Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Incoming Caller ID issue on CME

I use CME with IP phone, FXO card is use for PSTN connection with config listed below.

When I dial in, the IP Phone display the caller-id as 9999.

How can I fix it?

voice-port 1/0/0

plar connection 7001

caller-id enable

dial-peer voice 1 pots

destination-pattern 9991

forward-digit 3

port 1/0/0

dial-peer voice 2 pots

destination-pattern 9T

port 1/0/0

Thanks.

3 REPLIES
Bronze

Re: Incoming Caller ID issue on CME

First, did you perform "shut/no shut" after you added the "caller-id enable" command? If you didn't, then make sure you do that.

Next, what is happening is that on an inbound call, it is matching the first dial-peer that is enabled on that voice-port. So to solve this problem, do this.

dial-peer voice 10 pots

incoming called-number .

port 1/0/0

Let me know how that goes. Thanks.

Tony

New Member

Re: Incoming Caller ID issue on CME

The caller id become unknown for this time.

Is this the Telephone line not provide Caller-id or any config on CME to allow Caller-id.

Thanks.

Bronze

Re: Incoming Caller ID issue on CME

To find out if line is providing caller-id, enable the following debug and make an inbound call.

debug vpm signal

If there is caller-id being presented by line, it will show there. If no caller-id is being presented, you will see that also.

1291
Views
0
Helpful
3
Replies