02-27-2009 01:45 PM - edited 03-15-2019 04:31 PM
Hello, we have cucm 5.1 when we receive call we see Siemens and the caller number , siemens was the old phone system , how can i block the siemens writing allowing the caller id only?thanks.
02-27-2009 01:50 PM
Hello,
Are these callers calling from phones connected to a Siemens PBX, or are the calls coming from the PSTN directly to the CUCM?
02-27-2009 02:10 PM
All of the incoming call,even from a cell phone and still shows Siemens.
03-02-2009 07:11 AM
This is what i see from debug isdn, i need to edit the siemens. thanks.
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98391
Exclusive, Channel 17
Display i = 'SIEMENS'
03-02-2009 09:47 AM
To what are you connected ?
Are you using H.323 ?
03-03-2009 06:41 AM
the Gateways are two 3845 using MGCP. they are configured with PRI and CAS ,what i was told is that the guy who configured the system asked them if the want to see anything on the phone and they said siemens. i just can't find where to change this.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: