Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Incoming caller id

Hello, we have cucm 5.1 when we receive call we see Siemens and the caller number , siemens was the old phone system , how can i block the siemens writing allowing the caller id only?thanks.

5 REPLIES

Re: Incoming caller id

Hello,

Are these callers calling from phones connected to a Siemens PBX, or are the calls coming from the PSTN directly to the CUCM?

New Member

Re: Incoming caller id

All of the incoming call,even from a cell phone and still shows Siemens.

New Member

Re: Incoming caller id

This is what i see from debug isdn, i need to edit the siemens. thanks.

Bearer Capability i = 0x8090A2

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98391

Exclusive, Channel 17

Display i = 'SIEMENS'

Hall of Fame Super Gold

Re: Incoming caller id

To what are you connected ?

Are you using H.323 ?

New Member

Re: Incoming caller id

the Gateways are two 3845 using MGCP. they are configured with PRI and CAS ,what i was told is that the guy who configured the system asked them if the want to see anything on the phone and they said siemens. i just can't find where to change this.

274
Views
0
Helpful
5
Replies