Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Incoming calls disconnect very ofen

Hello,

Our client using Cisco 3600 Router + Isdn Qsig Voice Card + Gatkeeper

All clients are registring into the cisco gatekeeper.

Problem facing : Some times No Incoming calls, Enpoints are registered.

Q931 Debug:

Oct 8 11:29:01: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8 callref = 0x6059

Sending Complete

Bearer Capability i = 0x9090A3

Standard = CCITT

Transfer Capability = 3.1kHz Audio

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98389

Exclusive, Channel 9

Progress Ind i = 0x8583 - Origination address is non-ISDN

Calling Party Number i = 0x00A3, N/A

Plan:Unknown, Type:Unknown

Called Party Number i = 0xA1, '348741246'

Plan:ISDN, Type:National

Oct 8 11:29:01: ISDN Se0/0/0:15 Q931: TX -> CALL_PROC pd = 8 callref = 0xE059

Channel ID i = 0xA98389

Exclusive, Channel 9

Oct 8 11:29:01: ISDN Se0/0/0:15 Q931: TX -> DISCONNECT pd = 8 callref = 0xE059

Cause i = 0x80FF - Interworking error; unspecified

Oct 8 11:29:02: ISDN Se0/0/0:15 Q931: RX <- RELEASE pd = 8 callref = 0x6059

Oct 8 11:29:02: ISDN Se0/0/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0xE059

Oct 8 11:29:03: ISDN Se0/0/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0xADD9

Cause i = 0x8090 - Normal call clearing

Progress Ind i = 0x8288 - In-band info or appropriate now available

Please help me on this issue

2 REPLIES
New Member

Re: Incoming calls disconnect very ofen

What CM version are you running ? Have you checked your interfaces are clear of errors/slips.

New Member

Re: Incoming calls disconnect very ofen

What commands do you use if you wanted to check your serial interfaces of errors/slips?

192
Views
0
Helpful
2
Replies