Hi All, I have incoming calling problem from PSTN to my 2951 router when I configure. this configuration below is working fine, but when I dial any of my DID numbers from my mobile it goes to the pilot number (8888), I want to translate each number to specific extension my DID range is 06621125XX, I want to translate 0662112525 to 8888 which is the PILOT number for call Center contains of 4 phones and again each phone from call center called outside number should use the same number 0662112525.
then I want to translate these for individuals, like managers sales man each number for each person the translation should be back and forth.
0662112523 to 8747
0662112524 to 8748
isdn switch-type primary-net5 !
! voice hunt-group 1 parallel list 8742,8743,8744,8745 pilot 8888
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.