Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Incoming calls on FXO interface

Hello,

following situation:

I have a 2600XM running CME 3.3 on it, with a VIC-2FXO-EU. I'm able to make outgoing calls to the POTS, but not able to take calls from the POTS. Infrastucture looks like this:

POTS <---> PBX <---> 2600XM <---> IP network

Any ideas on this?

regards Dirk

regards, Dirk (Please rate if helpful)
2 REPLIES

Re: Incoming calls on FXO interface

you only need a pots dial-peer, something like this:

dial-peer voice 40 pots

description ***** FXS *****

destination-pattern 9788587772

port 0/0/1

New Member

Re: Incoming calls on FXO interface

Hi,

there is no FXS interaface on the "inside". Running Cisco's Ip Communicator on my ip network

regards, Dirk (Please rate if helpful)
213
Views
0
Helpful
2
Replies