incoming calls ring to a dial tone

[michaeljbyrne]

uc 560

incomming calls to DID's ring to a dail tone

dial-peer voice 150 pots
  incoming called-number .T
direct-inward-dial
port

any ideas?

[Brandon Buffin]

What type of PSTN connection? PRI, POTS? If POTS, add the following to the voice port config:

voice-port 0/0/0

connection plar 100 (This will be the DN that you want incoming calls to ring to)

Hope this helps.

Brandon

[michaeljbyrne]

PRI connection

[Brandon Buffin]

Try changing the command to "incoming called-number ."

You can also run "debug voip dialpeer" to make sure that this dial peer is being matched on an incoming call.

Brandon

[Abu Hadee]

do you have any other pots dial-peer?

try "debug voip ccapi inout" to find which incoming dial-peer it is matching.

Thanks

- abu

[Walter Solano]

Hello Michael.

Please try to change the "incoming called-number .t" to "incoming called-number .", another think that could be causing this issue its another dial-peer has been match as an incoming dial-peer please run a "debug voip CCAPI" when the call its coming into the system that will let us know which one its the true incoming dial-peer.

HTH

Please rate this post if was helpful

Walter Solano

CCVP, Cisco UCCX Specialist

Cisco IP Communications Express Specialist