Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

incoming is ok but outgoing is not working

One starnge problem, inbound calls are working but outbound calls from CUCM is not ok. PSTN Lines (FXO) are ok, as i have tested by analogue phone.

Following is the error.

QADHLNR0012901#sh voice iec description 1.1.278.5.88.0

    IEC Version: 1

    Entity: 1 (Gateway)

    Category: 278 (Media Negotiation Failure due to non-existing Codec)

    Subsystem: 5 (H323)

    Error: 88 (Fast codec mismatch)

    Diagnostic Code: 0

1 ACCEPTED SOLUTION

Accepted Solutions
Green

incoming is ok but outgoing is not working

Hi,

Looks like you are failing due to H323 FastStart

On the CUCM page for the H323 gatway look at the OUTGOING CALLS section.

Have you selected "Enable Outbound Faststart" , have you selected the correct codec for Faststart.

You could just try unticking the Faststart and retest.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
1 REPLY
Green

incoming is ok but outgoing is not working

Hi,

Looks like you are failing due to H323 FastStart

On the CUCM page for the H323 gatway look at the OUTGOING CALLS section.

Have you selected "Enable Outbound Faststart" , have you selected the correct codec for Faststart.

You could just try unticking the Faststart and retest.

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
928
Views
0
Helpful
1
Replies
CreatePlease to create content