Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Incoming PSTN Calls

Dear Friends

I have an issue with my ip phones, i want all the phones (5) to ring when the call lends at the router. can any one please help me with this, the system is working fine just wanna resolved the above issue. There are four 7912 phone and one 7940 phone

Cheers

Aamir

4 REPLIES
New Member

Re: Incoming PSTN Calls

Hi Amir

You should probably mention if you're using Communications Manager or Communications Manager Express and what version of it.

Regards

Stefan

New Member

Re: Incoming PSTN Calls

Hi Stefan

Sorry for the delay in replying, Its communication manager express version 4.0

Cheers

Aamir

Cisco Employee

Re: Incoming PSTN Calls

Hi Aamir

Looks like you want a shared line or overlaid DN.

You need to assign the same ephone-DN on all the ephones.

ephone-dn 1

number 1000

ephone 1

button 1:1

|

ephone 2

button 1:1

|

|

|

ephone 5

button 1:1

You might get more help from this link:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebasic.html#wp1013228

Regards

Pedro

Re: Incoming PSTN Calls

Hi Aamir,

It's not quite like that. You can see the configuration guide for CME 4.0 shared lines will utilize a number of overlaid. Note that each DN will only have 2 channels, so for 5 lines you will want to use more than one DN like the example that Pedro provided. If you want each user to be able to have 2 lines ( in this case a maximum of 10) you will want to configure 5 dual line DNs.

Something like this will help;

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmecover.html#wp1099687

hth,

nick

119
Views
0
Helpful
4
Replies
CreatePlease to create content