Closest-match routing is used to determine which route pattern matches the number most closely and the call is routed using that route pattern. Order of partitions in the CSS is only used to break a tie when two or more patterns in different partitions match equally.
The route pattern in the LD partition is 9.@, which includes several patterns, including (9)([2-9]X[02-9])(XXXX) which is a closer match for the dialed number than the route pattern in the local partition, which is 9.[2-9]XXXXXX.
If the route pattern in the local partition should be matched instead, change it from 9.[2-9]XXXXXX to 9.[2-9]x[02-9]XXXX. Since the device CSS has local partition above the long distance partition, the order will break the tie.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...