Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Installation CUCM 7 - "No driver found"

I insert the DVD in the tray of the server and I restart the server, so it boots from the DVD. The wizard of the installation of CIsco Unified Communication is showed. The question of the Wizard or Initial Configuration are showed, these question are as following:

Choose Lenguage, Keyboard Type and Installation Method.

In the Installation Method, I select Local CDROM and OK, but the next message is showed:

No driver found

Unable to find any devices of the type needed for this installarion type.

Would you like to manually select your driver or use a driver disk?

Because of this, I have not made ​​progress in the installation.

you could give me any suggestions?

(I am using a UCSc210m2 Server)

  • IP Telephony
Super Bronze

Installation CUCM 7 - "No driver found"


You can't isntall CUCM on a C-series. You have to install VMware ESXi and then install CUCM into a virtual machine.



Please rate helpful posts..

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

Installation CUCM 7 - "No driver found"

When you say you reboot the server are you talking about the physical host or a virtual machine? On the UCS platform, the idea is that you are running a hypervisor (ESXi 4.1+) and your CUCM OS/Application is being installed in a virtual machine running on that UCS compute platform.

See here for a VOD covering the UC on UCS solution:

See this for UC virtualization Wiki:




HTH -Bill (b) (t) @ucguerrilla

Please remember to rate helpful responses and identify