Installing CUCM 7 on MCS-7825H-3.0

[helawamry]

Hi,

I have MCS-7825H-3.0, we have upgraded the HDD's for the servers with 2 146 HDD's SCSI connected to the HP smart array 642.

When i try install CUCM 7.0, i get this critical error:

/dev/hda is not a hard disk, failed media type check.

Note;

There is no HDD's connected directly to the ATA of the motherboard.

The server supports installing CUCM 7.0, i have problem for allowing the CUCM 7.0 detect HDD's connected to the HP smart array controller.

[shaikh ibrahim]

Hi,

      check this link may be it will helpful for you ..

http://http://www.cisco.com/en/US/products/hw/voiceapp/ps378/products_tech_note09186a00800942b4.shtml#upgrade

Br

Sibrahim

[helawamry]

Hi shaikh,

Thank you for your reply, I was searching for this error and i find that Linux Redhat Ent. 4 running to detect HDD connected to the motherboard directy and it couldn't and also it couldn't detect HDD's connected to the HP smart array controller.

I don't know how i can let Linux Redhat Ent. 4 detect HDD connected to HP smart array controller.

Thanks

Helawamry

[yahsiel2004]

Have you configured the HP Smart Array Controller? If you haven't you must configure the array first and then you should detect the hdd?

Regards,

Yosh

[helawamry]

Hi Yosh,

I have configured the HDD connected to the HP smart array controller with RAID 1, is there anything else to i have to configure.

Thanks

Helawamry