Installing device packs on cucm 6- has it changed?
I recently uploaded a device pack on CUCM 6 to add a new phone type , I `ve done this before on 4.x and 5.x . On 4.x when you install the pack, you can instruct CUCM to install the new phone loads in to TFTP only but do not update the device defaults so you can manually control when you wish to update the phones, this was also the case on 5.x though it was not as obvious however on 6.x this seems to have disappeared. We have installed a device pack on two different CUCM 6.0 and on both occasions it updated all the phone loads in the device defaults without the option - has the process changed now or did I miss something ?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4