I have a customer that has a qsig trunk between a callmanager 6.1 and a NOrtel option 11. The gateway is a 2800 mgcp router. Outgoing calls from the ccm go through the option 11 and out to the pstn. The wrong number/main number is showing up as the caller id on outbound calls from the CCM. Calls from the Nortel shows the correct caller id. The debug shows a difference between the ccm and option 11, which is the num plan. Option 11 shows the num plan as E164. CCM shows the num plan as unknown. Could this be the reason for the Carrier sending the main number as the caller id, instead of the DID. Debug shows the correct number being delivered from the ccm to the Nortel, but not the num plan, which is showing up as unknown. Any ideas on how to resolve this issue? Thanks in advance for any help!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...