Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

integrating cme with ccm

hi, i am integrating a cme v 7.0 with a ccm 4.1, using h323 protocol, in the cme, i created a dial-peer voip pointing to the ccm's ip add, and in the ccm, y create a gateway h323, pointing to the cme ip add, and then the route pattern with the specific gateway.

the problem is, when an cme ip phone call to an ccm extension, it rings, the call establishes but after 4 sec the call is disconnected.

if the call is from the ccm phone to the cme phone, the call works fine,

the cause is temporary failure (41),

do you know why does this cause happen?

4 REPLIES
Hall of Fame Super Silver

Re: integrating cme with ccm

Instead of H323 GW configure intercluster trunk on the CM side.

Chris

New Member

Re: integrating cme with ccm

hi, i tried but the calls comming from the cme to the ccm fail. the only calls that work is from the ccm to cme.

the other thing i reviewed was, the region, for using the 729, and the location, bw voice = unlimited, this was applied to the gw config in the ccm.

Re: integrating cme with ccm

Hi Giovanni,

Try these things, they may help:

dial-peer voice x voip

no voice-class codec

codec g711u

no vad

incoming called-number .

interface fa0/0

h323-gateway voip bind src-address 1.1.1.1

On CCM:

In the H323 gateway page:

Check 'Enable Inbound Fast Start'

Uncheck 'Wait for Far-End H245 TCS'

Reset gateway

hth,

nick

Hall of Fame Super Gold

Re: integrating cme with ccm

Hi,

do you have "codec g711u" under the DP for CCM? Which setting do you have on CCM for the CME GW ?

173
Views
0
Helpful
4
Replies