Integrating Seimens Hipath 4000 PBX with CCM5.1 at separate locations
Hi, I need to integrate a CCM5.1 with a Seimens Hipath 4000 PBX. I dont have a problem if integrating in same location, but in this senario, the CCM is in one location and the PBX is in another location as shown in the attahced diagram. Please how do i go about this?
Re: Integrating Seimens Hipath 4000 PBX with CCM5.1 at separate
The only consideration to take into account when traversing the WAN is QoS configured outbound on the WAN interfaces:
* Make sure RTP traffic is placed in a priority queue
* Place your call signaling in a separate queue, but not the priority queue. Strip the DSCP for this traffic out to the cloud if there isn't a separate queue in the provider MPLS cloud for this traffic.
If you need more details on a sample QoS for a WAN, let me know and I can provide you with a sample config.
And if you have the capacity to configure fast start (if h323) or early offer (if SIP), it would be more ideal. in scenarios with latency on the WAN links to prevent delay in audio cut-through.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.