Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Integration between CUCM and VCS with h.323

Dear All,

 

can i integrate CUCM adn vcs using h.323? the deployment guide just state using SIP

i try to add vcs as h.323 in callmanager, and in vcs, i add cm as infrastructure. i can call to endpoint in vcs, but can not call from endpoint in vcs to ip phone in call manager.

any idea?

 

Thx,

Anju

5 REPLIES
Bronze

 The recommended way would be

 

The recommended way would be to use SIP.

 

However you can register a call manager to VCS using H323 as a H225 Gatekeeper Controlled trunk and use a prefix.

 

I would also check your route patterns, calling search spaces, etc on the UCM side

Community Member

Hi Hearthrw, meet again :

Hi Heathrw,

 

meet again :)

already done.  i add it as h.323 gateway, but i change the signaling port to 1720 (default is 1719) to match the vcs configuration.

i haven't tried your suggestion on my other thread. i update later.

 

Thx,

Anju

Did you checked Inbound call

Did you checked Inbound call section on H323 GW ? Is every thing there are correct ? CSS , Significant digits ?

Why H323 ? Why not SIP ? Any special reason behind it ?

 

Thanks

Manish

Community Member

Hi Manish, The integration

Hi Manish,

 

The integration already done, works well.

 

Thx,

Anju

Does inbound call work ? Did

Does inbound call work ? Did you checked CSS on GW inbound call section?

Thanks

Manish

147
Views
0
Helpful
5
Replies
CreatePlease to create content