Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Integration of Polycom PathNavigator and CUCM 6.0

We are looking to Integrate Cisco CUCM 6.0 (callmanager) with PathNavigator, Calls between IP Phones and Video Endpoint works only on one way, Cisco IP Phones can dial Video endpoints without problems, Video Endpoint can not dial IP Phones.

Here is what I have configured on CUCM.

1. I have PathNavigator registered as GK

2. Trunk configured as GK controlled (Type Gateway)

3. The Polycom Endpoints as H.323 Phones controlled by GK.

4. Route pattern (7XXX) using the Trunk to PathNavigator

As result of the above configuration on CUCM I can see two new endpoints GW RASAgregator and GW trunk. Also On the Services I can see the 1# prefix pointing to the Gateway (CUCM).

If I dial from IP Phone to he Video Endpoint works.

If Video Endpoint dial to IP Phone FAIL.

Im dialling with "1#IPPhone extension" (1#8200) or 98200.

None of them works,.

4 REPLIES
Bronze

Re: Integration of Polycom PathNavigator and CUCM 6.0

Need some more details. Can you post the following from the GK:

show version

show run

show gatekeeper end

show gatekeeper gw

New Member

Re: Integration of Polycom PathNavigator and CUCM 6.0

The Gatekeeper is a Polycom Path Navigator, so I can not give to you the show commands you are asking..

But, You may have an answer for the next situation...

Becauase Path Navigator and CUCM doesn't work well (At least I can not make them work) I Configured a Cisco GK and CUCM and both work very well But I need to Know how to make the GK work with Polycom V2IU 5300-E. I need to know how to configure the V2IU to forward incomming calls to the Cisco GK and how to make the Video Endpoint able to dial (IP) out of my network trough the V2IU.

Any help will be appreciated.

New Member

Re: Integration of Polycom PathNavigator and CUCM 6.0

Hi,

I'm trying a similar thing.

I have a CUCM 6.x  IOS GK trying to pass a call to a remote PathNavigator GK

So far I've registered the trunks but had no sucess at a call level.

Advise would be appricated.

Regards

Nick

New Member

Re: Integration of Polycom PathNavigator and CUCM 6.0

No news yet, I had that project on hold for a while. Now Im taking

it back. Did you made any progress on integrati

ng PathNavigator with Cisco GK?

If so, could you please share the configs on PathNav and Cisco GK?

REgards.

491
Views
0
Helpful
4
Replies