Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Intercluster trunk between CM4 and CM6

Is it possible to have an intercluster trunk between a CM4 and CM6. I have configured one but for some unknown reason whenever I phone a number destined for the other CallManager I get a fast busy about 5 secs. Any ideas?

1 REPLY

Re: Intercluster trunk between CM4 and CM6

it is possiable !

have you checked that the aproparate CSS and partions configured on the ICT, route pattrens

also do u habe regions, locations might make problems but not with ip phone to ip phone, unless there is bandwidth limitations thats why u need to make sure its ok

good luck

if helpful Rate

156
Views
0
Helpful
1
Replies
CreatePlease to create content