Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Intercluster trunk between cucm and cme

Hello,

       I have CUCM 9.0 in my head officed  and CME 4.0 in BO. I have create the ICT from my CUCM and the call flow works fine form HO to BO. 

 

               I  know CME doesnt supports Inter Cluster Trunk so I have to make the dial peer on the CME, can any one help me sharing the template how to do it ? 

 

 

       

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Its very simple.dial-peer

Its very simple.

dial-peer voice 1 voip

decsription inbound dial-peer for calls from cucm

incoming called number.

no vad

dtmf-relay h245-alpha

dial-peer voice 2 voip

destination-pattern xxxx (where xxxx=your cucm extension pattern)

session target ipv4: y.y.y.y (where yyyy=cucm ip address

dtmf-relay h245-alpha

no vad

dial-peer voice 1 voip

incoming called number.

no vad

dtmf-relay h245-alpha

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
6 REPLIES
VIP Super Bronze

Its very simple.dial-peer

Its very simple.

dial-peer voice 1 voip

decsription inbound dial-peer for calls from cucm

incoming called number.

no vad

dtmf-relay h245-alpha

dial-peer voice 2 voip

destination-pattern xxxx (where xxxx=your cucm extension pattern)

session target ipv4: y.y.y.y (where yyyy=cucm ip address

dtmf-relay h245-alpha

no vad

dial-peer voice 1 voip

incoming called number.

no vad

dtmf-relay h245-alpha

Please rate all useful posts "The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
New Member

I dont understand why I have

I dont understand why I have to make 2 Dial Peers.

dial-peer voice 1 voip

decsription inbound dial-peer for calls from cucm

incoming called number.

no vad

dtmf-relay h245-alpha

dial-peer voice 2 voip

destination-pattern xxxx (where xxxx=your cucm extension pattern)

session target ipv4: y.y.y.y (where yyyy=cucm ip address

dtmf-relay h245-alpha

no vad

Dial peer 1 is to receive the

Dial peer 1 is to receive the calls from CUCM and dial peer 2 is to send the calls to CUCM. If incase the call doesn't work after those configurations, please collect the following debugs Debug voice ccapi inout Debug h225 asn1 Debug h245 asn1
//Suresh Please rate all the useful posts.
New Member

When I am trying to put the

When I am trying to put the command

 incoming called number.  

Incorrect format for E.164 Number
        regular expression must be of the form  ^[][^0-9,A-F#*.?+%()-]*T?(\$)?$

 

 

 

New Member

Thanks it worked 

Thanks it worked 

VIP Gold

Don't forget to add h323

Don't forget to add h323-gateway voip bind srcaddr <ip address>  to the interface of CME.

 

Suresh

823
Views
0
Helpful
6
Replies
CreatePlease login to create content