There are three clusters here all connected via non-GK intercluster trunks on CCM 4.2(3)sr2b. Right now, Cluster 3 cannot dial Cluster 1 (busy), but Cluster 1 can dial Cluster 3. The ICT from Cluster 3 to Cluster 2 is working fine both ways. They are using the same MRGL and device pool. I have attached the ccm to this post.
I am trying to find some information about this error, but I have been unsuccessful so far. Does anyone have any ideas?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...