cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
480
Views
0
Helpful
5
Replies

Intercluster Trunk with 6.1

CleverDrake
Level 1
Level 1

We have set up an intercluster trunk between two CCM 6.1 clusters. The voice quality is great, but there is an issue with resources. We can place calls on hold, but there is no hold music, just the three beeps. We know we have resourcecs available, but for some reason it is not pulling them. Any documentation on this issue?

5 Replies 5

Jaime Valencia
Cisco Employee
Cisco Employee

no, that's misconfiguration. make sure that the phones and ICT have a valid MRGL with an MOH server in it. this on both sides. also confirm the IPVMS is using the codec you're using for the calls, if not enable them trhu IPVMS service parameters

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

Would this have anything to do with not being able to transfer calls, or park calls? These are also features that are not working.

most probably, check you have MTP required on both incoming GW and ICT

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

When we had the MTP checked we were recieving a fast busy once we pressed Hold. We unchecked it, and that is when hold started working. Is a MTP required for a trunk connecting two Cisco Clusters?

If so, why was it not working at all when it was checked?

pemelend
Level 4
Level 4

Hi

The tone on hold is caused by different causes. This link has some very good documentation

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_qanda_item09186a0080094766.shtml#q16

Thanks

Pedro

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: