Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Intercluster Trunk

Hi,

I have an intercluster trunk setup between two call managers.  How can I define what codec should be used on this trunk?

thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Intercluster Trunk

Use Locations and Regions for this configuration:

Locations and regions work in conjunction with one another. Regions define the codec (G.711, G.722, G.723, G.729, GSM, or wideband) that is used on the link, and locations define the amount of available bandwidth for the link. You assign each device in the system to both a region (by means of a device pool) and a location.

What version of CUCM are you using?

Hailey

1 REPLY

Re: Intercluster Trunk

Use Locations and Regions for this configuration:

Locations and regions work in conjunction with one another. Regions define the codec (G.711, G.722, G.723, G.729, GSM, or wideband) that is used on the link, and locations define the amount of available bandwidth for the link. You assign each device in the system to both a region (by means of a device pool) and a location.

What version of CUCM are you using?

Hailey

404
Views
0
Helpful
1
Replies
CreatePlease to create content