Intercluster with callback redundant solution question
We have one cluster of 2 call managers (5.1) that communicate with another cluster (4.x) via intercluster trunk. This is used for internal calls and for external calls also. We also have a link for failover of external calls to a primary rate interface (PRI-NET5) via a 2811 GW (H323). In order to have callback to work we have enabled tunneling of QSIG via the intercluster. However, recursively from hunt lists this makes our 2811 H323 link to tunnel QSIG which does not work. How can we overcome this problem without using any more intercluster trunks, including SIP trunk that does not work for our purposes?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...