Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

interface standby on CCM

Hi all, is there a chance to configure some standby mode on two ethernet interfaces on CCM server, I mean to connect them to different switches and in case of link failure (for example because of switch failure) the standby interface would be able to retake connectivity? Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: interface standby on CCM

Hi Thomas,

Just to add a link to the good info from Chris and Jaime. CCM 4.2(1) is good;

Using the Cisco Media Convergence Server Network Teaming Driver with Operating System Version 2000.4.4

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/win_os/driver/team_244.html

Hope this helps!

Rob

4 REPLIES
Hall of Fame Super Silver

Re: interface standby on CCM

Yes, it is supported to configure NIC teaming in CallManager. What version of CM do you have?

Chris

New Member

Re: interface standby on CCM

I have 4.2(1)

Cisco Employee

Re: interface standby on CCM

just as a note this is only supported on HP servers

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Hall of Fame Super Red

Re: interface standby on CCM

Hi Thomas,

Just to add a link to the good info from Chris and Jaime. CCM 4.2(1) is good;

Using the Cisco Media Convergence Server Network Teaming Driver with Operating System Version 2000.4.4

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/win_os/driver/team_244.html

Hope this helps!

Rob

112
Views
0
Helpful
4
Replies