Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Intergrating a fax machine into cisco Callmanager express

Hi,

I need some help (Configuration guide)on how to integrate a fax machine onto Cisco Callmanager express 4.0 or later connected via an FXS card.

5 REPLIES
New Member

Re: Intergrating a fax machine into cisco Callmanager express

What exactly are you looking for here? Are you just trying to route specific DID's (or a single DID) to a specific FXS port?

New Member

Re: Intergrating a fax machine into cisco Callmanager express

Hi Kplunkett,

Thanks for the response. I am actually trying to route a single DID to specific FXS port which has the FAX machine connected to it.

Have any configuration guides or urls i can follow.

Hall of Fame Super Gold

Re: Intergrating a fax machine into cisco Callmanager express

dial-peer voice XXX pots

destination-pattern ZZZ <-- number a received from telco

port x/y/z

Then check you have network-clock commands set also.

New Member

Re: Intergrating a fax machine into cisco Callmanager express

Let's assume you're getting 4 digits from the carrier, and the last four of the DID number is 8878.

*******************

First ensure the voice port is configured:

voice-port 0/1/1

description Fax Machine

Then configure the routing of the DID to your fax port:

dial-peer voice 29 pots

description Fax Machine

destination-pattern 8878

port 0/1/1

forward-digits all

That should do it. Hope this helps!

Hall of Fame Super Gold

Re: Intergrating a fax machine into cisco Callmanager express

Hi, watch out that if you have "forward-digits all" for a FXS port as in the example above, router will playout these digits after fax answer the calls, that may not be the desired behavior...

169
Views
0
Helpful
5
Replies