Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

intermittent fax issue

Howdy,

I have a 2811 router with 1 primary rate and 1 fxs interface. On the fxs interface i have a fax machine. The fax call comes in over the pri and is sent to the fxs interface. Unfortunately there are a lot of failures with the inbound faxes. Even from the same numbers. About 4/10 fail.

Now when running the debug isdn q931 and voip ccapi the only thing i can see is that vad is on for the inbound fax call and as the fax is on a pots interface can this make a difference? Can i rectify by adding a generic voip interface with no vad even though this is an inbound fax and inbound dial-peer is 1 and outbound is 2?

Anything i can try to resolve?

Config:

isdn switch-type primary-net5

!

voice-card 0

no dspfarm

!

password encryption aes

!

voice call send-alert

voice rtp send-recv

!

voice service pots

!

voice service voip

allow-connections h323 to h323

h323

!

!

!

voice class codec 1

codec preference 1 g711ulaw

codec preference 2 g729r8

!

!

!

voice class h323 1

h225 timeout tcp establish 3

isdn switch-type primary-net5

isdn incoming-voice voice

isdn map address 1* plan unknown type unknown

isdn sending-complete

voice-port 0/3/0:15

!

voice-port 0/2/0

ring cadence pattern04

input gain -6

cptone NZ

impedance complex1

!

voice-port 0/2/1

ring cadence pattern04

cptone NZ

dial-peer voice 1 pots

description Incoming POTS Dial Peer

incoming called-number .

direct-inward-dial

port 0/3/0:15

forward-digits all

dial-peer voice 2 pots

description Branch Fax

destination-pattern 1234

port 0/2/0

3 REPLIES
Hall of Fame Super Gold

Re: intermittent fax issue

This is a FAQ

Please configure:

network-clock-select 1 e1 0/3/0:15

And report again.

New Member

Re: intermittent fax issue

Yes i already have that assigned just didnt put it in the config sample.

network-clock-participate wic 3

network-clock-select 1 E1 0/3/0

New Member

intermittent fax issue

Hi

I have come across a very similar issue. Please could you let me know how this issue got resolved.

Thanks

217
Views
0
Helpful
3
Replies
CreatePlease to create content