Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Internal calls to phone not ringing while on call

User 1 is on external call, internal user 2 calls user 1, user 2 hears ring for 10 seconds then voicemail picks up. When caller 2 is dialing user 1, user 1 does not see user 2 is calling at all. This only occurs when user 1 is on another call. Customer is using old versions of cme and cue. I feel like this is something simple, but I can't seem to figure it out.
  • IP Telephony
3 REPLIES

How are the buttons setup on

How are the buttons setup on users 1 phone? Can you post the config?

Regards,

Yosh

HTH Regards, Yosh

What you are looking for is

What you are looking for is Maximum Number of Calls and Busy Trigger

Example:

ephone 2
privacy-button
mac-address XXXX.XXXX.XXXX
ephone-template 1
max-calls-per-button 5  << inbound & outbound
busy-trigger-per-button 2 << only inbound
button 1:2 2:3

 

New Member

What do you have configure

What do you have configure under call-forward noan  command? 10 sec? Can you please post the config at least of the phone you are having problems with?

 

As well as the debug callmonitor  to see what´s going with the call.

 

Please provide exact call flow.

 

calling number, called number, exact time of the call.

37
Views
0
Helpful
3
Replies
This widget could not be displayed.