Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Internaltional dial peer isdn call type "International"

Hi. I am having an issue on a PRI so that with a dialpeer when i send 011 followed by the number it is being flaged as isdn type international and telco is dumping the call. if i dont prefix the 011 is is flagged as unknown which is also being dumped

I need to flag the call ISDN type as unknown when i prefix with 011. I cant figure out how to do this

dial-peer voice 3 pots

numbering-type unknown

destination-pattern 9011T

port 0/0/0:23

prefix 011

debug output

Bearer Capability i = 0x8090A2

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98397

Exclusive, Channel 23

Calling Party Number i = 0x2181, '3123245277'

Plan:ISDN, Type:National

Called Party Number i = 0x91, '011441865314280'

Plan:ISDN, Type:International

*Sep 4 00:06:57.287: ISDN Se0/0/0:23 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x810C

4 REPLIES
New Member

Re: Internaltional dial peer isdn call type "International"

Heres how I do it.

!

!

voice translation-rule 2

rule 2 /\(011*\)/ /\1/ type any unknown

!

voice translation-profile intunk

translate called 2

!

dial-peer voice 3 pots

translation-profile outgoing intunk

destination-pattern 9011T

port 0/0/0:23

prefix 011

Re: Internaltional dial peer isdn call type "International"

Hello,

I had this same issue with a customer yesterday. Under the D-channel interface enter the following:

interface Serialx/x/x:23

isdn map address ^011 plan unknown type unknown

Hope that helped, if so please rate.

New Member

Re: Internaltional dial peer isdn call type "International"

nice one Kenneth - 5 points from me

New Member

I have a question about this

I have a question about this.

Disregard....I figured it out.  removed my question

 

1685
Views
15
Helpful
4
Replies
CreatePlease to create content