Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Internation Dialing

                   Our Norfolk office is not able to dial International numbers. We called our vendor and they did a call trap and determined that the number is being sent incorrectly from our equipment. Our gateway or CM seems to be removing 2 digits in the country code.  Any ideas on where to start?

We are running CM 7.1.3

2 REPLIES
Cisco Employee

Internation Dialing

If MGCP is used, then it has to be in CUCM, check all elements involved in the call routing (GW/RG/RL/RP), maybe TPs or something else

If H323, also add the actual H323 config (DPs/translation rules) to the above.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Internation Dialing

Hi all,

Make sure your dial-peer (for outgoing calls) looks like this:

dial-peer voice 1 pots

destination-pattern 0T

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

progress_ind connect enable 8

incoming called-number .

direct-inward-dial

port 0/0/0:15

forward-digits all

!

Cheers,

Cesar

129
Views
0
Helpful
2
Replies
CreatePlease login to create content