International Call configuration on T1 (CAS) - CM 4.2

[tpatten]

Need some insight on how to configure T1 CAS for international calls outgoing.

Dial-peer configuration is as follows:

dial-peer voice 120 pots

description International

numbering-type international

destination-pattern +011T

port 0/1/0:1

forward-digits all

Using CM 4.2 with a route pattern 9.011!#

discard digits predot Trailing-#.

we also tried adding a route filer to the pattern to include the international access, country code, etc.

We are Receiving a busy signal.

Also when dialing through the gateway it does not show any matching dial-peer.

Thank you for the assist

[Brandon Buffin]

Change your dial peer to:

destination-pattern 011T

Brandon

[tpatten]

Thank you for the quick response. We made this change and added the "^". This has fixed the connection issue.