Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

International calling through ccm

We have one ccme 4.1 version and one ccm 4.2 version , the outside ,int calling from ccme is routed through the ccm , in ccm we have partitions ,css and client matter code to make international call , how i can use the client matter code from the ccme to make international call.Few users are moving from ccm to ccme for voice mail facility ,the ccme user need to use the same ccm client matter code for international calling. kindly provide your valuable suggestions and reply

regards sunny

2 REPLIES
Green

Re: International calling through ccm

The CMC should be entered in CME, there no way to do this in CCM, since call is not originated from an IP Phone in CCM.

You may create special Route Patterns in CM reachable only using the CSS from CME which not contain CMC or FAC enabled.

Here is a good info from Rob in how to configure that in CME.

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cbeab43/1#selected_message

New Member

Re: International calling through ccm

Thankyou for your document and explanation about the scenario

221
Views
5
Helpful
2
Replies
CreatePlease to create content