Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

International callings

Need to strip 4011 from an international call

Route pattern is 4.@ and I am using DDI "pre dot" I have captured a debug on my gateway and my called party number is 011XXXXXXXXXX my provider needs me to strip the 011 off of this call. Any ideas on the best way to do this?

H323 Gateway

CM 4.1.3

1 ACCEPTED SOLUTION

Accepted Solutions

Re: International callings

Try changing route pattern to 4011.@ and strip pre-dot and see if this gives the desired behavior.

Also, what do you international dial peers look like?

Hope that helped

1 REPLY

Re: International callings

Try changing route pattern to 4011.@ and strip pre-dot and see if this gives the desired behavior.

Also, what do you international dial peers look like?

Hope that helped

104
Views
0
Helpful
1
Replies