Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Interoperability with HiPath 3800

Hi All,

Hi,

I am trying to implement Interoperability between CUCM and Siemens HiPath 3800, I have enable Qsig and completed all the required configuration,

Detail's

1.Controller E1 up

2.Serial port up

3.ISDN status is Multiple-frame-established

My problem is, I am not able to dial any of the extention in Siemens and vice-versa,

The debug gives Cause i = 0x81E6 - Recovery on timer expiry

when try to reach from Siemens I am getting a Busy tone,

Kindly check the Running configuration attached and help in troubleshooting this issue,

3 REPLIES
New Member

Re: Interoperability with HiPath 3800

Hi,

Are you sure the QSIG version is the same on both side: on Cisco QSIGv1 is ECMA, and QSIGv2 is ISO.

Just in case, the CCO URLs for Cisco-Siemens HiPath QSIG configs:

QSIGv2: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/603504nt.pdf

QSIGv1: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/pbx/interop/notes/607736nt.pdf

cheers

jp

New Member

Interoperability with HiPath 3800

Hi ajkhader123

Could you solve this problem.

I am facing exactly the same problem.

Thank you in advance

Green

Interoperability with HiPath 3800

Youssef,

You have 2 posts in which refer to other quite old postings

May be you should start a new post and explain your set up and the issues.

Include your configs etc

Regards

Alex

Regards, Alex. Please rate useful posts.
781
Views
0
Helpful
3
Replies
CreatePlease to create content