Invalid call reference value

[acharyr123]

Hi,

I have a PRI terminated into Cisco 2821 Router. All the 30 chanels are allocated to us. The problem is from Voice gateway whenever we make outbould calls we get the error message " Cause i = 0x8AD1 - Invalid call reference value ". But we can find the calling party no in the router.

Plz find the debug for the outbound calls.

=============================================================

aredxbhobvgwan01#isdn test call interface serial 0/1/0:15 2337777

4294967296w4294967296d: ISDN Se0/1/0:15 Q931: Sending SETUP callref = 0x00AD callID = 0x802E switch

= primary-net5 interface = User

1w0d: ISDN Se0/1/0:15 Q931: TX -> SETUP pd = 8 callref = 0x00AD

Bearer Capability i = 0x8890

Standard = CCITT

Transfer Capability = Unrestricted Digital

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9839F

Exclusive, Channel 31

Called Party Number i = 0x81, '2337777 '

Plan:ISDN, Type:Unknown

1w0d: ISDN Se0/1/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0x80AD

Channel ID i = 0xA9839F

Exclusive, Channel 31mon

1w0d: ISDN Se0/1/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x00AD

Cause i = 0x8AD1 - Invalid call reference value

1w0d: ISDN Se0/1/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x00AD

Cause i = 0x80E6 - Recovery on timer expiry

4294967296w4294967296d: ISDN Se0/1/0:15 **ERROR**:CCPCC_CallOrigination:SETUP timed-out (2nd T303) to NETWORK.The SETUP failed.

====================================================================

All parameters are in sync with ISP.

Plz suggest.

[paolo bevilacqua]

Exact IOS? Can you send show controllers E1 ?

[chrysostomos1980]

Hi to all

i didnt open a new document since we have the same problem here

Pls someone can help with this problem

i am experiencing the same problem(But this time the problem appeared only in incoming calls and not to outgoing)

ei controller 0/1/0

incoming:problem

outgoing:ok