Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Invisible Route Pattern

This one has me stumped!!

I have a building that needed an interface to overhead paging, so I used an ATA186 and wired into the paging system that way.  Users must pick up the phone and dial *1 to overhead page.  So my problem here is I would like to check this setup against another building I am trying to do the same thing in.  In CCM 4.1(3) I can find nothing under Route Patterns for *1.  The 2801 at the site is H323, again, nothing in the config under translation patterns for *1, and the 3560 that has the ATA of course has nothing for *1.  Yet it works, LOL!!!  Where would I find the *1 pattern and how it is setup?  This is so weird!

Thanks anyone.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Invisible Route Pattern

is it possilbe that it is a translation pattern? Check the Route Plan Report for anything starting with *1.

2 REPLIES
New Member

Re: Invisible Route Pattern

is it possilbe that it is a translation pattern? Check the Route Plan Report for anything starting with *1.

New Member

Re: Invisible Route Pattern

Thanks, that helped.  It was installed as a Directory Number.

Not sure of the benefit of that, but hey it works!

178
Views
0
Helpful
2
Replies
CreatePlease to create content