Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS software MTP

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1004679

I have read the docs on how to configure software based MTP on an IOS router but my understanding is that when a DSP Farm is created it uses DSP recourses?? Am I wrong in assuming this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: IOS software MTP

From your link:

MTP

Software-only implementation that does  not use a DSP resource for endpoints with the same codec and the same  packetization time.

Hardware-only implementation using a  DSP resource for endpoints with the same G.711 codec but a different  packetization time.

Note Because a software-only MTP does not require DSP  resources, you can configure a software-only MTP without a voice network  module, or on the NM-HDV if you do not enable the dsp services dspfarm command for the voice card.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1 REPLY
Cisco Employee

Re: IOS software MTP

From your link:

MTP

Software-only implementation that does  not use a DSP resource for endpoints with the same codec and the same  packetization time.

Hardware-only implementation using a  DSP resource for endpoints with the same G.711 codec but a different  packetization time.

Note Because a software-only MTP does not require DSP  resources, you can configure a software-only MTP without a voice network  module, or on the NM-HDV if you do not enable the dsp services dspfarm command for the voice card.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
2211
Views
0
Helpful
1
Replies