Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ip Communicator 2.1.3 Japanese language problem Audio tuning Wizard

Hi,

Installing Ip communicator 2.1.3 using the exe file on a pc with Japanese language installed. The install runs fine (with Japanese fonts). But after the install and starting up ip communicator, the audio tuning wizard runs. The buttons on the audio tuning wizard are blank (where there is supposed to be Ok, Next or Cancel buttons).

Another problem when using the msi to install, the language is English on this same pc. Is there an optional switch to allow the install to run with Japanese fonts.

Thanks

  • IP Telephony
104
Views
0
Helpful
0
Replies
This widget could not be displayed.