Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IP Communicator and Cisco Router 2901 - CME

Hi,

We recently moved from an ICS 7750 solution to a Cisco Router 2901 with CME/CUE.

When I launch my the IPC software, it seems to boot up. I can see our directories, etc. But the user extension/name do not appear.

What CLI information is missing here?

Thanks,

Phil....

3 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: IP Communicator and Cisco Router 2901 - CME

Sounds like CIPC auto registered to CME but there was no ephone-dn available to assign to the ephone.

Look at the configuration of CME and check to see if there is an ephone defined with the mac-address of the CIPC PC and no "button" configuration.

Cisco Employee

Re: IP Communicator and Cisco Router 2901 - CME

hmm...IPC? U trying to register and use CIPC with CME ?

If yes, did u build an ephone and associate DNs for it

in CME?

Please provide more info...

Cisco Employee

Re: IP Communicator and Cisco Router 2901 - CME

Yeah, just add the button CLI for CIPC ephone to tie the DN (ephone-dn)

and then reset/restart the ephone.

4 REPLIES
Cisco Employee

Re: IP Communicator and Cisco Router 2901 - CME

Sounds like CIPC auto registered to CME but there was no ephone-dn available to assign to the ephone.

Look at the configuration of CME and check to see if there is an ephone defined with the mac-address of the CIPC PC and no "button" configuration.

Cisco Employee

Re: IP Communicator and Cisco Router 2901 - CME

hmm...IPC? U trying to register and use CIPC with CME ?

If yes, did u build an ephone and associate DNs for it

in CME?

Please provide more info...

New Member

Re: IP Communicator and Cisco Router 2901 - CME

Okay, I notice that there is no ephone assigned for the CIPC.

The user already has an ephone-dn assigned. So, would the config look similar to this?

ephone-dn  17  dual-line
number 890 no-reg primary
label Test x890
description 123-456-7890
name Test User call-forward busy 799
call-forward noan 799 timeout 20

ephone  8
video
mac-address (IP Phone MAC Address)
ephone-template 10
username "cme890" password voicemail
paging-dn 1
type 7940
button  1:17

ephone  9
video
mac-address (IP Communicator MAC Address)
ephone-template 10
username "cme890" password voicemail
paging-dn 1
type CIPC

Thanks,

Phil..

Cisco Employee

Re: IP Communicator and Cisco Router 2901 - CME

Yeah, just add the button CLI for CIPC ephone to tie the DN (ephone-dn)

and then reset/restart the ephone.

443
Views
0
Helpful
4
Replies