Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP communicator cannot use services

Hi, all!

My IP Communicator registered with CUCM 6.1 and subscribed on Extension Mobility service. I can see this service in IP Communicator but when check him I see "Host not found". On the IP Phone all services work. I try change CUCM hostname on IP address and service URL but it not help.

And another problem, VT advantage 2 work with one 7970 phone and don`t work with anotger 7970 phone. They have the same settings.

1 REPLY
Silver

Re: IP communicator cannot use services

go through the following steps:

On the callmanager make sure the following parameters have the IP address instead of the hostname in the URL:

System > Enterprise Parameters::URL Authentication

System > Enterprise Parameters::URL Directories

System > Enterprise Parameters::URL Services

System > Enterprise Parameters::URL Information

System > Enterprise Parameters::Enable All User Search* >> should be set to TRUE

System > Enterprise Parameters::Enable All User Search* >> Set this to a value greater than 0

Restart IIS service. Start>Programs>Administrative Tools>Services, right click on the and select

If IIS fails to restart, please open a cmd prompt window and type:

C:\>iisreset /start

Also, try restarting Tomcat service.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080093e72.shtml#host

http://www.cisco.com/en/US/products/hw/phones/ps379/products_qanda_item09186a00800a6763.shtml

153
Views
0
Helpful
1
Replies