Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP Communicator CM6

I've been using IPC for a long time and just upgraded to CM6. Now at home over a VPN, I no longer can use IPC. If I call Unity I see packets going both ways, and hear the Unity prompts, but Unity apparently can't hear me. If I call into my CRA IPIVR system, I only show packets from my phone and I don't hear any of the IPIVR Prompts. If I call another CMS subscriber, they can hear me, but I can't hear them. CM6 shows my phone with the IP address of my private network. All of the get.asp instructions state it only applies to Windows. How do I tell CM6 that I'm Natted and really have a 10.X.X.X address?

1 REPLY
Green

Re: IP Communicator CM6

get.asp dont think it may work in 6.x because of Tomcat

Which VPN client you use ?

If you put an sniffer capture which interface we are sending/reciving packets?

Check this common bug for IPC CSCsd69887

113
Views
0
Helpful
1
Replies