Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IP Communicator display time on CUCME

I have an issue with the correct time being displayed on CIPC. There are 2 configured in the system and they both are exactly 4 hours fast. No other phone has this issue. The router has the correct time, NTP is accessible and working and the time zone is configured under telephony services so I am all out of ideas! Can anyone think of anything?

Thanks

Sent from Cisco Technical Support iPhone App

6 REPLIES
Cisco Employee

IP Communicator display time on CUCME

Create an ephone template and specify the phone type.

Apply that template to the ephone configurations with the time issue.

Reset the phones.

That should fix the problem.

New Member

Re: IP Communicator display time on CUCME

The phone type is defined on the ephone but I will try it with CIPC in the ephone template and reset. Thanks for the reply

Sent from Cisco Technical Support iPhone App

New Member

Re: IP Communicator display time on CUCME

Hi ,  How to creat a ephone template?

Can you please expain this on steps Thanks

Cisco Employee

Re: IP Communicator display time on CUCME

Create the template:

CUCME(config)#ephone-template  1  <---Doesn't have to be 1

CUCME(config-ephone-template)#type CIPC  <---Phone type, CIPC is for Cisco IP Communicator

Then on your phones:

CUCME(config)#ephone 1

CUCME(config-ephone)#ephone-template 1  <--This needs to match the number used above.

Then reset the phone.

New Member

Re: IP Communicator display time on CUCME

That didn't work defining the type under the template vs the type on the actual ephone. Thanks for the suggestion though. Any other ideas anyone?

Sent from Cisco Technical Support iPhone App

Re: IP Communicator display time on CUCME

conf t

telephony-service

time-zone ?

reload router

240
Views
0
Helpful
6
Replies
CreatePlease to create content