Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IP Communicator long press touch tones

I have IP Communicator 8.6.2.0 running from CUCM  7.1.5.32900-2.  I was wondering if there is a way of setting it up, as I can't find it anywhere, so that if I hold down on a number I get a continous touch tone.  I have an emergency phone on campus that requires a long press of # for two seconds to disconnect after programming.  I have setup a 7960 to do it but would like to do it without having to break out a second phone if I don't have to.  If there is no way of switching this that is fine as well.  I can hold down on a number on the number pad but it is not a continous tone, it is a stutter.

1 REPLY
Cisco Employee

Not AFAIK, this is not a

Not AFAIK, this is not a signal as an analog phone, this is a single message that you pressed something on the phone.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
17
Views
0
Helpful
1
Replies
CreatePlease to create content