I am testing IP communicator v2.0 with call manager v4.0(2a)sr2c. Most of the ipt communicator functions and voice quality are working well in the office LAN. Except, there is no MOH when remote calling party puts (ipt phone model 7940)the call to MOH. At IPT communicator, I hear intermittent short beep sound instead of normal moh music wave sound. There is moh when ipt communicator ext put the called party on hold. Did I miss some configuration in call manager? Do I need to activate multicast feature in media resource group? I need some coaching to resolve the issue. Thanks in advance.
If you use Locations-Based Call Admission Control, users at remote sites (for example, across a WAN link) cannot use MoH. Remote site users cannot use this feature because bandwidth calculations across location boundaries do not take into account MoH streams. In place of MoH, these users receive Tone on Hold (ToH), and bandwidth calculations are then correct.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...