Some of our homeworkers are experiencing issues with their headset or handset they use with IPCommunicator.
They've said that there is an alert message at times that appears when closing down the ip communicator saying "can not save settings".
This means that when they next log on to the communicator the auto tuning wizard appears with a request to 'check audio settings' as 'some audio devices have never been configured to use with Cisco IP Communicator'.
When this happens the handset/headset, make/model option is not available from the drop downs.
We have had a user bring their laptop in and we have reinstalled all software, handset drivers etc. But then it happens again. I have to issue instructions on setting up their usb phone/headset from scratch.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.