Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IP Communicator with Cisco Call Manager Express

Is possible to use Ip comuniactor with CME? If so, can any one provide the configuration steps please.

3 REPLIES
Hall of Fame Super Red

Re: IP Communicator with Cisco Call Manager Express

Hi Sudheer,

Support for IP Communicator was added in CME 4.0 Have a look at the steps below;

SCCP: Configuring Cisco IP Communicator Support

To enable support for Cisco IP Communicator, perform the following steps.

Prerequisites

Cisco Unified CME 4.0 or a later version

Cisco IP Communicator 2.0 or a later version

IP address of the Cisco Unified CME TFTP server

(Optional) Headsets with microphones for users

DETAILED STEPS

--------------------------------------------------------------------------------

Step 1 Download the latest version of the Cisco IP Communicator software and install it on your PC.

The download website is at http://www.cisco.com/pcgi-bin/tablebuild.pl/ip-iostsp.

Step 2 (Optional) Attach a headset with microphone to your PC.

Step 3 Start the Cisco IP Communicator application.

Step 4 Define the IP address of the Cisco Unified CME TFTP server.

a. Open the Network > User Preferences window.

b. Enter the IP address of the Cisco Unified CME TFTP server.

Step 5 Wait for the Cisco IP Communicator application to connect to Cisco Unified CME and register.

Step 6 Configure the extension numbers and line buttons for the Cisco IP Communicator.

Use the normal phone provisioning commands described in the "SCCP: Creating Directory Numbers" section. In the type command, use the CIPC keyword to identify this phone as a Cisco IP Communicator.

--------------------------------------------------------------------------------

SCCP: Verifying Cisco IP Communicator Support

--------------------------------------------------------------------------------

Step 1 Use the show running-config command to display ephone-dn and ephone information associated with this phone.

Step 2 After Cisco IP Communicator registers with Cisco Unified CME, it displays the phone extensions and soft keys in its configuration. Verify that these are correct.

Step 3 Make a local call from the phone and have someone call you. Verify that you have a two-way voice path.

--------------------------------------------------------------------------------

SCCP: Troubleshooting Cisco IP Communicator Support

--------------------------------------------------------------------------------

Step 1 Use the debug ephone detail command to diagnose problems with calls. For more information, see the Cisco Unified CME Command Reference.

--------------------------------------------------------------------------------

From this good doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00807e13a7.html#wp1046762

Hope this helps!

Rob

Community Member

Rob THANKS AGAIN !!! Enrique

Rob THANKS AGAIN !!!

 

Enrique Villasana

Community Member

Re: IP Communicator with Cisco Call Manager Express

Thanks Rob

I am able to configure the IP communicator and it is registering with CME. I have another question.. how can i configure IP communicator to use my desk phone number instead of giving a new number.

Thanks

6811
Views
5
Helpful
3
Replies
CreatePlease to create content